Swissbit presents pSLC with it’s new S-46 and S-46u series
Swissbit, the leading European manufacturer of DRAM and flash memory solutions, presents its new S-46 and S-46u series SD and Micro SD memory cards for applications demanding high endurance and performance. Both products combine the market’s latest MLC flash components with a page based firmware translation layer (FTL) and a single bit per cell storage mode. This results in highest random performance and an endurance that exceeds that of industry standard SD memory cards considerably.
The Swissbit S-46 SD memory cards with capacity from 2 GB to 64 GB and S-45u Micro SD memory cards from 2 GB up to 16 GB, work in a storage mode where only a single bit is used per MLC cell. This pSLC mode can be operated much faster than standard MLC mode and increases the permitted program-erase (PE) cycles of MLC from the specified 3k to 20k. Under equal conditions this increases the endurance by a factor of 6.6 at doubled bit cost. In addition the sub-page based FTL allows the firmware to reduce the write amplification to very low values especially for random writes. Compared to standard industrial SD memory cards the resulting endurance can be up to 600 times greater. The S-46/S-46u cards comply with UHS-I bus mode, up to speed class 10 and offer a sequential data rate close to 50 MB/s and a blazing random write data rate of up to 1400 IOPS.
- highest random performance
- increased PE cycles up to 20k (compared to standard MLC)
- increased endurance up to 600 times greater (compared to standard MLC)
- sequential data rate close to 50 MB/s
- random write data rate of up to 1400 IOPS
The new Swissbit products are equipped with the proven read disturb management (RDM) alongside an autonomous, performance-neutral background “auto refresh” process. This type of data care management extends the data reliability especially in read intensive applications. Thanks to the sub-page based management the busy time is kept below the specified limit under all conditions, allowing a high sustained IOPS rate and guaranteeing compatibility with the most widespread industrial and networking SD applications.
By using pSLC mode, the protection against data loss during a sudden power fail had even been improved. The supporting Swissbit life time monitor (SLTM) offers highly detailed status information about the cards and provides a valuable prediction of the expected lifetime allowing for scheduled maintenance.
- latest MLC flash components
- page based firmware translation layer (FTL)
- single bit per cell storage mode
- read disturb management (RDM)
- auto refresh
- up to speed class10
- protection against sudden power fail
- S-46 SD memory cards with capacity from 2 GB to 64 GB
- SD memory cards from 2 GB up to 16 GB
Samples will be available beginning Q4 2016.
Contact our SpecialistSHOP NOW