Fujitsu relay solutions for the lighting industry

TLED lighting in offices

If safety is a very crucial criterion in the replacement of the TLED fixture then relays are used in a system. The relays are able to provide appropriate galvanic spacing between uninsulated accessible parts.

This safety requirement is necessary for TLEDs with connections on both ends of the tube. Suitable relays are the FTR-C1, FTR-F1 and or FTR-B3 series. These relays can provide the necessary creepage and clearance distance, while at the same are small enough to be mounted inside the TLED tube.

FTR-C1

2 POLE-2A High insulation/wide gap of 0.6mm
FTR-C1 Series
High surge voltage: 2,500V between open contacts
5,000V between coil & contact
Complies with Telcordia 2nd Level Lightning Surge Test for Telecom Ports
Dielectric strength: 1,500VAC between open contacts 3,000VAC between coil and contact

FTR-B3

ULTRA MINIATURE RELAY
2 POLE – 2A (Low Profile Signal Relay)
FTR-B3 Series
Complies with Telcordia GR1089/ FCC part 68
- Isolation distance: min. 1.6mm
- Dielectric strength between coil and contact: 1,500VAC
- Surge strength: 2,500V
FTR-F1
Power Relay
- 2 Pole – 5A (Low Profile Power Relay)
  - Contact form 2NO or 2 CO
  - Available 8A type -FTR-F1R
  - TV-3 rating available
  - Coil Voltage 1,5V to 110V