Infineon – EVAL-M3-CM615PN – Modular Application Design Kit with CIPOS™ Mini and iMOTION™

Infineon – EVAL-M3-CM615PN – Modular Application Design Kit with CIPOS™ Mini and iMOTION™

EVAL-M3-CM615PN

The evaluation board is based on the IFCM15P60GD, CIPOS™ Mini single phase PFC integrated 3 phase IPM. In
combination with control-boards, like EVAL-M3-102T, it features and demonstrates CIPOS™ Mini IPM technology
and Advanced Motion Control Engine (MCE 2.0) technology for permanent magnet motors drive over the full speed
range.

Features:
– Power stage to drive 3-phase motor
– Power Factor Correction(CCM boost PFC topology)
– 600 V blocking voltage
– 15 A installed chip current
– 650W output power with passive cooling
– Test pads with hooks to attach standard oscilloscope probes
– Standard MADK™ M3 interface connector

Benefits:
– Enable easy evaluation of IFCM15P60GD, CIPOS™ Mini IPM
– Complete motor drive system set-up within one hour in combination with Eval-M3-102T
– Fast time to market by reduced design time and effort

Target application:
– HVAC compressors
– Motor control & drives
– Pumps
– Fans

Application example: Air conditioner compressor

Competitive advantage:
Rapid prototyping various inverterized motor control systems in combination
with active PFC

Value proposition:
– Easy to set up a complete motor drive system in less than 1 hour
– Time to Market – dramatically reduce R&D time

Block diagram:

Evaluation board:
Power Board : EVAL-M3-CM615PN
Connector board : EVAL-M3-102T

Products collaterals / Online support:
– Product presentation
– iMOTION™ Motor Control overview
– User manual
– MADK page

Product overview incl. data sheet link: